Enterasys RBTSA-AA Guide de l'utilisateur télécharger pdf (Page 18)

12 CHAPTER 2: INSTALLING THE ETHERNET ADAPTER

Figure 3 shows the front view of the Ethernet Adapter, including the LEDs and

connecting ports. It also shows the cradle, which is used to mount the

Ethernet Adapter to a wall or to install the Ethernet Adapter on a flat surface.

Figure 3 Ethernet Adapter

Observing Safety

Precautions

This equipment must be installed in compliance with local and national

building codes, regulatory restrictions, and FCC rules. For the safety of

people and equipment, only professional network personnel should

install the Ethernet Adapter.

WARNING: To comply with FCC radio frequency (RF) exposure limits, a

minimum body-to-antenna distance of 20 cm (8 in.) must be maintained

when the Ethernet Adapter is operational.

WARNING: To avoid possible injury or damage to equipment, you must

use either the provided power supply or power supply equipment that is

safety certified according to UL, CSA, IEC, or other applicable national or

international safety requirements for the country of use. All references to

power supply in this document refer to equipment meeting these

requirements.

WARNUNG: In Übereinstimmung mit den von der FCC (Federal

Communications Commission) festgelegten Grenzwerten für die

Einwirkung von Radiowellen muss bei Betrieb des Ethernet-Adapters der

Abstand zwischen Körper und Antenne 20 cm betragen.

WARNUNG: Zur Vermeidung möglicher Verletzungen oder Schäden am

Gerät muss entweder das mitgelieferte Netzteil oder ein Netzteil

verwendet werden, das von der UL (Underwriters Laboratories Inc.), CSA

Power Port

11a/b/g Wireless

Ethernet Adapter

Serial Port

Ethernet Port

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 69 70

Pas de commentaire

Enterasys RBTSA-AA Guide de l'utilisateur Page 18