Enterasys C3G124-48P Guide d'installation télécharger pdf (Page 28)

10BASE-TX Network

2-2 Network Requirements

10BASE-TX Network

Whenconnectinga10BASE‐TXsegmenttooneoftheRJ45 fixedportsonboththe 

C3G124‐24PandtheC3G124‐48P,ensurethatthenetworkmeetstheEthernetnetwork

requirementsoftheIEEE802.3‐2002standardfor10BASE‐TX.RefertotheCablingGuide

fordetails.

100BASE-TX Network

Whenconnectinga100BASE‐TXsegmenttooneoftheRJ45fixedportsonboththe

C3G124‐24PandtheC3G124‐48P,useCategory5UTPcabling.Theswitchattheotherend

ofthetwistedpairsegmentmustmeetIEEE802.3‐2002100BASE‐TXFastEthernet

networkrequirementsforthe

switchestooperateat100 Mbps.

1000BASE-FX Network

TheMini‐GBICportsocketsontheC3G124‐24PandC3G124‐48Penableyoutovarythe

typeof1‐Gbpsportconnection.Thedeviceattheotherendofthesegmentmustmeetthe

sameGigabitEthernetrequirementsfortheconnecteddevicestooperateat1‐Gigabit

speed.Referto

Table 1‐2onpage 1‐6foralistofMini‐GBICscurrentlyavailablefrom

Enterasys Networks.

1000BASE-T Network

TheRJ45fixedfrontpanelconnectorssupportRJ45copper1000BASE‐Tcompliant 

connections.Whenconnectinga1000BASE‐TsegmenttooneoftheRJ45fixedports,use

Category5UTPcablingorbetter.Thedeviceattheotherendofthetwistedpairsegment

mustmeetIEEE802.3‐20021000BASE‐T

GigabitEthernetnetworkrequirementsforthe

devicestooperateat1000 Mbps.

TheC3G124‐24PandC3G124‐48Pcansupport1000BASE‐Tcopperconnectionsthrough

MGBIC‐02sinstalledintheMGBICportslots.

Note: If a port is to operate at 100 or 1000 Mbps, Category 5 cabling must be used.

Category 3 cabling does not meet the 100 or 1000 Mbps specifications. For 10 Mbps

operation only, Category 3, Category 4, or Category 5 cabling can be used. Refer to

100BASE-TX Network (page 2-2) and 1000BASE-T Network (page 2-2) for information

about 100BASE-TX and 1000BASE-T networks and cabling.

Note: When using the fixed ports on the switch for 100 Mbps operation use Category 5

UTP cabling with an impedance between 85 and 111 ohms for 100 Mbps operation.

Depending on the switch used, the fixed switch ports are capable of operating at 10 or

100 Mbps

,orat10, 100, or 1000 Mbps. This is accomplished when Auto-Negotiation is

enabled, allowing the switch to automatically sense the transmission speed of the other

device and adjust for the speed accordingly.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 77 78

Pas de commentaire

Enterasys C3G124-48P Guide d'installation Page 28