Enterasys C3G124-48P Guide d'installation télécharger pdf (Page 62)

Using LANVIEW

4-4 Troubleshooting

Table 4-1 LANVIEW LED Diagnostic Indications

LED Color State Recommended Action

CPU Off Power disconnected. If the LED remains off after connecting

AC power or DC power from an RPS,

check the following:

1. Make sure there is power at the

power source (AC source and RPS

if applicable).

2. Replace the power cord with a

known good one or check the

continuity of the power cord.

3. If the switch still does not power up,

the system may have a fatal error.

Contact Enterasys Networks for

technical support.

Red Solid. Boot-up failed. If the LED remains red for several

minutes, the system may have a fatal

error. Contact Enterasys Networks for

technical support.

Amber Solid. Diagnostics are running. If the LED remains amber for more than

several minutes, contact

Enterasys Networks for technical

support.

Blinking. Code image is being downloaded. None.

Green Solid. System is fully functional. None.

Blinking. Boot-up in process. None.

DOWN Off No valid connection to switch stack up

connector.

1. Make sure the switch connected to

the stack up connector is powered

on.

2. Replace cable with a known good

one.

3. If the problem still exists, contact

Enterasys Networks for technical

support.

Green Solid. Valid connection to switch stack up

connector.

Blinking. Information is being transferred

through the high-speed stacking cable.

None.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 77 78

Commentaires sur ces manuels

Pas de commentaire

Enterasys C3G124-48P Guide d'installation Page 62

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau Enterasys C3G124-48P