Enterasys APS-3000 Spécifications télécharger pdf (Page 433)

Enterasys Wireless Controller Software CLI Reference Guide 20-1

policy Commands

ThissectiondescribescommandsusedtodefineandconfigurepolicyfortheEnterasysWireless

Controller.ThesecommandsarelocatedinthepolicycontextoftheCLI.Executethepolicy

commandattherootleveltoenterpolicycontext.RefertoSection6.10,“ConfiguringPolicy,”in

theEnterasysWirelessControllerUserGuide

formoreinformationaboutpolicyconfiguration.

Apolicyisacollectionofattributesandrulesthatdeterminehowthetraffic,ofusersaccessingthe

wirednetworkthroughtheWLANservice,ishandled.Policy assignmentensuresthatthecorrect

topologyandtrafficbehaviorareappliedtoauserregardlessofSSID

orVNSassignment.Traffic

behaviorisdefinedinpolicybyconfiguringaratecontrolsettingandfilterrulesfortheACorAP.

Policiesdonotneedtobefullyspecified.Unspecifiedattributesareretainedbytheuseror

inheritedfromtheglobaldefault‐policy.Referto“default‐policy”on

page 18‐6forinformationon

configuringtheglobaldefault‐policy.

Apolicyeitherspecifiesordefaultsto:

•Atopology

•Aninboundandoutboundratecontrolprofile

•Asetoffilters

Thefollowingcommandsareavailableinthepolicycontext:

• create

• delete

• enable‐advance‐filtering

• show

• <named‐policy>—See<named‐policy>for

commandsinthetopology:<named‐policy>

context.

Note: All CLI commands cache changes. For this reason, sometimes when you make a change in a

particular context, the change may not be visible immediately. If this happens, you must exit and re-

enter the context in order to ensure that the database is synchronized with the latest change.

Note: The policy context was introduced with V7.0.

1 2 ... 428 429 430 431 432 433 434 435 436 437 438 ... 499 500

Pas de commentaire

Enterasys APS-3000 Spécifications Page 433