Enterasys Enterasys SecureStack B2 B2G124-24 Guide d'installation télécharger pdf (Page 6)

Safety Information

Class 1 Laser Transceivers

The single mode interface modules use Class 1 laser transceivers.

Read the following safety information before installing or operating these modules.

TheClass1lasertransceiversuseanopticalfeedbacklooptomaintainClass1operationlimits.Thiscontrolloop

eliminatestheneedformaintenancechecksoradjustments.Theoutputisfactoryset,anddoesnotallowanyuser

adjustment.Class1Lasertransceiverscomplywiththefollowingsafetystandards:

•21

CFR1040.10and1040.11U.S.DepartmentofHealthandHumanServices(FDA).

•IECPublication825(InternationalElectrotechnicalCommission).

• CENELECEN60825(EuropeanCommitteeforElectrotechnicalStandardization).

Whenoperatingwithintheirperformancelimitations,lasertransceiveroutputmeetstheClass1accessibleemission

limitofallthreestandards.Class1levelsoflaserradiation

arenotconsideredhazardous.

Whentheconnectorisinplace,alllaserradiationremainswithinthefiber.Themaximumamountofradiantpower

exitingthefiber(undernormalconditions)is‐12.6dBmor55x10

‐6

watts.

Removingtheopticalconnectorfromthetransceiverallowslaserradiationtoemitdirectlyfromtheopticalport.The

maximumradiancefromtheopticalport(underworstcaseconditions)is0.8Wcm

‐2

or8x10

Wm

sr‐1.

Donotuseopticalinstrumentstoviewthelaseroutput.Theuseofopticalinstrumentstoviewlaseroutput

increaseseyehazard.Whenviewingtheoutputopticalport,powermustberemovedfromthenetworkadapter.

1 2 3 4 5 6 7 8 9 10 11 ... 77 78

Pas de commentaire

Enterasys Enterasys SecureStack B2 B2G124-24 Guide d'installation Page 6