Enterasys SecureStack A2 A2H123-24 Guide d'installation télécharger pdf (Page 40)

Connecting AC and RPS-SYS Power

3-14 Hardware Installation

C2RPS-SYS Redundant Power System

Ifyouareinstallinganoptionalredundantpowersystem(C2RPS‐SYS),refertothe

installationinstructionssuppliedwiththeSecureStackRPS.Theswitchisconnectedtoa

C2RPS‐PSMusingaC2RPS‐PSMCable.

Figure 3-7 Accessing the RPS Connector

Ifyouareinstallingtheswitchasastandaloneswitch,proceedto“ConnectingtoConsole

Port

forLocalManagement”onpage 3‐15.Ifyouareinstalli ngswitchesinastack

configuration,applypowertoeachswitchinorder,accordingtotheproceduredescribed

in“ConfiguringSwitchesinaStack”onpage 3‐9.

1 RPS coverplate 3 Screw holes for coverplate

2 Retaining screws to fasten plate

Caution: To prevent damaging the switch, DO NOT connect a Power over

Ethernet-compliant Redundant Power System (C2RPS-POE) to the redundant power

supply connector. The switch is only compatible with the SecureStack C2RPS-SYS

redundant power supply system.

Precaución: No conecte una fuente de poder redundante (RPS) SecureStack PoE

(C2RPS-POE) al cable de corriente. De lo contrario, el dispositivo puede dañarse.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

Pas de commentaire

Enterasys SecureStack A2 A2H123-24 Guide d'installation Page 40