Enterasys VHSIM2-A6DP Guide de l'utilisateur Page 162

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 436
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 161
FLASH Download Configuration Screen
5-36 Module Configuration Menu Screens
5.8.1 Image File Download Using Runtime
To download a firmware image file to the switch module using Runtime, proceed as follows:
1. Use the arrow keys to highlight the Reboot After Download field.
2. Use the SPACE bar to select either YES or NO. Select YES if you want the module to reboot
after the download is completed. Select NO if you want the switch module to store the new
image in FLASH memory until the module is reset or during the next power-up.
3. Use the arrow keys to highlight the TFTP Gateway IP Addr field.
4. Set the IP address of the TFTP gateway (this defaults to the same IP address as that set in the
TFTP Gateway IP Addr field on the General Configuration screen).
5. Use the arrow keys to highlight the Download Server IP field.
6. Enter the IP address of the TFTP server using the DDN format.
For example: nnn.nnn.nnn.nnn
7. Use the arrow keys to highlight the Download File Name field.
8. Enter the complete pathway and file name of the image stored on the download server.
For example: /tftpboot/SS2200.fls
9. Use the arrow keys to highlight EXECUTE at the bottom of the screen and press ENTER. If
Reboot After Download is set to NO in step 2, the message “RUNTIME DOWNLOAD IN
PROGRESS” displays in the event message line at the top of the screen and the new image is
downloaded into FLASH memory. If Reboot After Download is set to YES in step 2, the
message “REBOOT WILL OCCUR AFTER DOWNLOAD COMPLETES” displays.
During the downloading process, the screen displays the Download Block Count (the number of
frames received).
Vue de la page 161
1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 435 436

Commentaires sur ces manuels

Pas de commentaire