Enterasys Vertical Horizon VH-8G Spécifications télécharger pdf (Page 35)

9033640 VH-8G User Interface 27

Configuring Port Parameters

Use the Port Configuration menus to set or display communication

parameters for any port on the switch.

Figure 2-20. Port Configuration

Vertical Horizon Local Management -- VH-8G

Port Configuration

: Port 1 - 8

Flow Control on all ports : [Enable] [Disable]

Port Type Admin Flow Speed and

Control Duplex

-------------------------------------------------------------------------

1. 1000SX ENABLED ENABLED 1000-HALF

2. 1000SX ENABLED ENABLED 1000-FULL

3. 1000SX ENABLED ENABLED AUTO

4. 1000SX ENABLED ENABLED AUTO

5. 1000SX ENABLED ENABLED 1000-FULL

6. 1000SX ENABLED ENABLED 1000-HALF

7. 1000SX ENABLED ENABLED AUTO

8. 1000SX ENABLED ENABLED AUTO

Use <TAB> or arrows keys to move. <Space> to scroll options.

Parameter Default Description

Flow Control on all

ports

DISABLED Allows you to enable or disable flow control for all

ports on the switch.

Type Shows port type as 1000SX (1000Base-SX)

Admin ENABLED Allows you to disable a port due to abnormal

behavior (e.g., excessive collisions), and then re-

enable it after the problem has been resolved.

You may also disable a port for security reasons.

Flow Control DISABLED Used to enable or disable flow control. Flow

control can eliminate frame loss by “blocking”

traffic from end stations or segments connected

directly to the switch when its buffers fill. Back

pressure is used for half duplex and IEEE 802.3x

for full duplex.

Speed and Duplex AUTO Used to set the current port speed, duplex mode,

and auto-negotiation.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 109 110

Pas de commentaire

Enterasys Vertical Horizon VH-8G Spécifications Page 35