Enterasys ANG-3000 Guide de l'utilisateur Page 150

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 414
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 149
116 XSR Users Guide
Configuring BAP Chapter 6
Configuring PPP
XSR1(config-if<BRI-2/0>)#no shutdown
XSR1(config-if<BRI-2/0>)#dialer pool-member 1 priority 0
3 Configure the Dialer 1 interface with a dialer pool:
XSR1(config)#interface Dialer1
XSR1(config-if<D1>)#no shutdown
XSR1(config-if<D1>)#dialer pool 1
XSR1(config-if<D1>)#encapsulation ppp
4 Set up BAP on Dialer 1 by specifying the load-threshold (BoD), enabling
BAP, and configuring XSR1 to initiate the addition of a link. Note that the
load threshold is very low, ensuring that BAP will be enabled relatively
quickly when traffic starts to build.
XSR1(config-if<D1>)#multilink load-threshold 4
XSR1(config-if<D1>)#ppp multilink bap
XSR1(config-if<D1>)#ppp bap call request
5 Complete Dialer 1 configuration by setting the idle timeout and dialer-
group values for DoD:
XSR1(config-if<D1>)#dialer idle-timeout 4000
XSR1(config-if<D1>)#dialer-group 2
XSR1(config-if<D1>)#ip address 99.99.1.2 255.0.0.0
6 Configure the dialer list and ACL for DoD:
XSR1(config-if<D1>)#access-list 102 permit icmp list 102
XSR1(config-if<D1>)#dialer-list 2 protocol ip list 102
XSR2 Configuration
XSR2 is configured to accept incoming calls only.
1 Begin configuring XSR2 by setting up the T1 controller (PRI interface):
XSR1(config)#controller t1 1/0
XSR2(config-controller<T1-1/0>)#pri-group
XSR2(config-controller<T1-1/0>)#isdn bchan-number-order ascending
XSR2(config-controller<T1-1/0>)#no shutdown
XSR2(config-controller<T1-1/0>)#dialer pool-member 1 priority 0
2 Configure BRI interface 2/0 with the basic-ni1 switch type and two SPIDs:
XSR2(config)#interface bri 2/0
Vue de la page 149
1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 413 414

Commentaires sur ces manuels

Pas de commentaire