Enterasys ANG-3000 Guide de l'utilisateur Page 375

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 414
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 374
XSR Users Guide 341
Chapter 13 Configuration Examples
Configuring Security on the XSR
XSR(config)#ip firewall policy exttodmzsmtp ANY_EXTERNAL dmz SMTP
allow bidirectional
XSR(config)#ip firewall policy TelnetSESS private Mgmt Telnet
allow bidirectional
Set a policy to allow any traffic to pass from private to EXTERNAL networks:
XSR(config)#ip firewall policy prvtoextprivate ANY_INTERNAL
ANY_EXTERNAL allow
Trial load the completed configuration into the firewall engine, and if
successful, load the configuration:
XSR(config)#ip firewall load trial
XSR(config)#ip firewall load
Complete LAN and WAN interface configuration:
XSR(config-if<F1>)#interface fastethernet 1
XSR(config-if<F1>)#ip address 220.150.2.35 255.255.255.0
XSR(config-if<F1>)#no shutdown
XSR(config)#interface fastethernet 2
XSR(config-if<F2>)#ip address 220.150.2.17 255.255.255.0
XSR(config-if<F1>)#no shutdown
XSR(config)#interface serial 1/0:0
XSR(config-if<S1/0:0>)#ip address 206.12.44.16/24
XSR(config-if<S1/0:0>)#no shutdown
Globally enable the firewall. Even though you have configured and loaded
the firewall, only invoking the following command “turns on” the firewall.
Once enabled, if you are remotely connected, the firewall will close your
session. Simply login again.
XSR(config)#ip firewall enable
Vue de la page 374
1 2 ... 370 371 372 373 374 375 376 377 378 379 380 ... 413 414

Commentaires sur ces manuels

Pas de commentaire