Enterasys SecureStack A2 A2H124-24FX Guide d'installation télécharger pdf (Page 36)

Installing the Switch on a Flat Surface

3-8 Hardware Installation

Figure 3-4 Chassis Bottom, Rubber Feet Placement

Guidelines for Flat Surface Installation

Locatetheswitchwithin152cm(5ft)ofitspowersourceandonasurfaceasshownin

Figure 3‐5.

Atemperatureofbetween0°C(32°F)and40°C(104°F)mustbemaintainedatthe

installationsitewithfluctuationsoflessthan10°C(18°F)

perhour.

Ifanoptionalredundantpowersystemisgoingtobeinstalledandconnectedtothe

14‐pinRedundantPowerSupplyinputconnectorontherearoftheswitch,

refertothe

installationguideshippedwiththeredundantpowersystem.

1 Bottom of chassis as seen when chassis is

resting on its back

3 Rubber feet with adhesive backing

(four)

2 Locations to install the rubber feet (four locations)

Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to

install the rubber feet on each switch before continuing with the installation.

ÂÂ

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 81 82

Pas de commentaire

Enterasys SecureStack A2 A2H124-24FX Guide d'installation Page 36