Enterasys SecureStack A2 A2H124-24FX Guide d'installation télécharger pdf (Page 37)

Installing the Switch on a Flat Surface

SecureStack A2 Installation Guide 3-9

Ifyouareinstallingseveralswitchesinastack,proceedto“ConnectingStackingCables”

onpage 3‐11.Iftheswitchisbeinginstalledasastandaloneswitch,proceedto

“ConnectingACandRPS‐SYSPower”onpage 3‐16forpowerconnectioninstructions.

Figure 3-5 Area Guidelines for Switch Installation on Flat Surface

Caution: To ensure proper ventilation and prevent overheating, leave a minimum

clearance space of 5.1 cm (2.0 in.) at the left, right, and rear of the switch.

Do not connect the switch to the AC power source until instructed to do so later in the

installation process.

Precaución: Para asegurar una buena ventilación y evitar que el sistema se

sobrecaliente, deje un espacio mínimo de 5.1 cm (2 pulgadas) con respecto a los lados y

a la parte posterior del aparato.

No conecte el dipositivo a la fuente primaria hasta que no se le indique.

1 Approximately 152 cm (5 ft) from power source 3 44.5 cm (19.4 in.) for proper ventilation

2 4.45 cm (1.75 in.) per switch. (Vertical clearance

depends on number of switches stacked.)

4 41.9 cm (16.5 in.) for proper ventilation

Console

CPU

RPS

MGR

1 3 5 7 9 11131517192123

2 4 6 8 10 12 14 16 18 20 22 24

25/Up 26/Down

Stack

2 8 10 1246

179113 5 13 19 21 2315 17

14 20 22 2416 18

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 81 82

Pas de commentaire

Enterasys SecureStack A2 A2H124-24FX Guide d'installation Page 37