Enterasys 2S4082-25-SYS Guide d'installation télécharger pdf (Page 38)

Installing the Chassis into a Rack

3-4 Enterasys Matrix N1 Chassis Setup

Installing the Chassis Directly to the Rack

ToinstalltheEnterasys Matrix N 1Chassis,proceedasfollows:

1. Liftthechassisintotherackandslideitallthewayintotherack.RefertoFigure 3‐1.

2. Use4screws(2perside)providedwiththeequipmentracktosecurethechassistotherack,

startingwiththebottomholesand

workingtowardthetopofthechassis,asshownin

Figure 3‐1.

Figure 3-1 Rack Mounting the Enterasys Matrix N1 Chassis

Attaching the Electrostatic Discharge Wrist Strap

TheElectrostaticDischarge(ESD)wriststrapmustbeattachedbeforehandlingthemodulesused

intheEnterasys Matrix N1Chassis.Inaddition,observeallprecautionswhenhandlingthese

modulestopreventdamagefromelectrostaticdischarge.

PlacetheESDwriststraponyourwristandplugtheotherendintothegroundingreceptacle,at

thetoprightcornerofthechassis,showninFigure 3‐2.

Caution: Read Chapter 2 before completing the following procedure to ensure that all installation

guidelines are met.

Precaución: Antes de llevar a cabo el siguiente procedimiento, lea Chapter 2 para y asegúrese

de cumplir con todos los requisitos de instalación.

Warning: To help prevent personal injury, at least two people are required to lift the chassis into

the rack.

Advertencia: Para ayudar a prevenir alguna lesión personal, al menos dos personas son

requeridas para levantar el chasis y meterlo al rack.

Warnhinweis: Zum Schutz vor körperlichen Schäden, sollten sie mit min. zwei Personen das

Chassis in das Rack heben.

1 Rails of 19-inch rack 2 Mounting screws (supplied by user)

Note: The Enterasys Matrix N1 Chassis must not exceed the 2U high rackmount standard and

must comply with the requirements for mounting in a 19-inch (48.26-centimeter) rack.

1 1

FAN

STATUS

PS1

STATUS

PS2

STATUS

GROUND

STRAP

7C111

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 107 108

Pas de commentaire

Enterasys 2S4082-25-SYS Guide d'installation Page 38