Enterasys 5C105 Guide d'installation télécharger pdf (Page 19)

1-1

Introduction

This chapter introduces the 5H152-50 and 5H153-50 Fast Ethernet modules.

The 5H152-50 module (Figure 1-1) features 48 10BASE-T/100BASE-TX switched ports

connected through 48 fixed RJ45 front panel connectors. There is also a slot for an optional

5PIM-G02 or 5PIM-G06 gigabit uplink interface.

The 5H153-50 module (Figure 1-1) features 48 10BASE-T/100BASE-TX switched ports

connected through 4 fixed RJ21 front panel connectors. There is also a slot for an optional

5PIM-G02 or 5PIM-G06 gigabit uplink interface.

Each of the fixed front panel ports can operate in either half-duplex or full-duplex mode of

operation, as determined by auto-negotiation. Full-duplex can also be manually configured.

The module ports can be configured to control traffic in several ways, including prioritizing traffic

flow according to protocol type. The module can also be configured to establish 802.1Q Virtual

Local Area Networks (VLANs) and control the flow of frames associated with each VLAN

according to priority and Ether type. Detailed information about VLANs is provided in the

MATRIX E5 Series Modules Local Management User’s Guide.

The module receives power and backplane connectivity when it is inserted into a 5C105 MATRIX

E5 chassis.

Important Notice

Depending on the firmware version used in the module, some features described in this document

may not be supported. Refer to the Release Notes shipped with the module to determine which

features are supported.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 77 78

Pas de commentaire

Enterasys 5C105 Guide d'installation Page 19