Enterasys 5C105 Guide d'installation télécharger pdf (Page 34)

Installing Optional GPIMs

3-6

4. Use the two saved coverplate screws ➅ to fasten the 5PIM ➁ to the module front panel ➂. Do

not tighten screws.

5. Fasten the 5PIM

➁ to the standoff ➀ using the last saved screw ➆. Do not tighten screw.

6. Now tighten the two coverplate screws

➅ first and then the standoff screw ➆ .

7. This completes the 5PIM installation. If you installed a 5PIM that accepts GPIMs, proceed to

Section 3.3 for the GPIM installation instructions. Otherwise, proceed to Section 3.4 to install

the module into the chassis.

3.3 INSTALLING OPTIONAL GPIMs

The optional GPIMs are hot-swappable and may be installed into the 5PIM-G06 before or after the

module (host module) is installed into the chassis. However, for convenience in a new installation,

it is recommended that you install GPIMs before installing the module in the chassis. In either

case, use the following installation instructions to prevent damaging either the GPIM or the host

5PIM-G06.

There are two different physical styles of GPIMs that can be installed into the module, as shown in

Figure 3-3. One style has the squeeze-latch side clips (Figure 3-3, view A); refer to Section 3.3.1

for the installation procedure. The other style has the locking bar (Figure 3-3, view B); refer to

Section 3.3.2 for the installation procedure.

CAUTION: The GPIM, 5PIM and module are sensitive to static discharges. Use an

antistatic wrist strap and observe all static precautions during this procedure. Failure to

do so could result in damage to the GPIM, 5PIM, or module. Always leave the GPIM in

the antistatic bag in which it was shipped or an equivalent antistatic container until ready

to install it.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 77 78

Pas de commentaire

Enterasys 5C105 Guide d'installation Page 34