Enterasys 5C105 Guide d'installation télécharger pdf (Page 69)

Setting the Mode Switches

Mode Switch Bank Settings B-3

• Switch 6 – No function.

• Switch 7 – Clear NVRAM. Changing the position of this switch resets NVRAM on the next

power-up of the device. All user-entered parameters, such as the IP address, device names, etc.,

are reset to the factory default settings. Once the module resets, you can either use the factory

default settings or reenter your own parameters.

• Switch 8 – Reset Password/Community Names. Changing the position of this switch clears

user-entered passwords stored in NVRAM, and restores the factory default passwords on the

next power-up of the device. Once the module resets, you can either use the factory default

settings or reenter your own passwords.

NOTE: Do not change the position of Switch 8 unless it is necessary to reset the

super-user configured passwords to their factory default settings.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 77 78

Pas de commentaire

Enterasys 5C105 Guide d'installation Page 69