Enterasys C2RPS-SYS Guide d'installation télécharger pdf (Page 44)

Connecting AC and RPS-SYS Power

3-16 Hardware Installation

Figure 3-9 Switch Rear View

3. ObservethepowerCPULED(notshown),locatedonthefrontpanel.Duringthe

initialization,theCPULEDwillstartbyilluminatingsolidamber,thenstartblinking

green,thenblinkingamber,thenblinkinggreenagainuntiltheendofthe

initialization,andthenturnssolidgreen.

Iftheswitchisa

standaloneswitch,itwilltakeapproximately30secondsforthe

switchtostartup.IftheswitchisastackManager,itcantakeupto3minutesormore

tostartup,dependingonthenumberofMemberswitchesinthestack.

1 AC power cord 2 AC power connector 3 Connector for external redundant power supply

Note: If the CPU LED illuminates solid red, there was a critical failure. For more

information about the LED indications and troubleshooting, refer to Chapter 4. If you need

additional help, contact Enterasys Networks. Refer to “Getting Help” on page 1-6 for

details.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 79 80

Pas de commentaire

Enterasys C2RPS-SYS Guide d'installation Page 44